This will disappear from the display after a few seconds and the Receiver will return to its normal The display will show now the Firmware version's.
Holding it press the “STANDBY/ON” button. Then press and hold the “DISPLAY” button and while Now the update is complete! You can check that it has been successful if you read out the FW
Not switch OFF automatically, in this case wait for another 10 minutes before switching OFF manually.ģ. “Complete!”, then “Clear”, then the Receiver will go to Standby mode. Now you see “Writing 2 st DSP…” than again S/DIF Update before itĬhanges to “Writing 3 st DSP…” When the writing process has finished the display will say
Will now say “S/PDIF Update…” for about 15 seconds then “Writing 1 st DSP…” for about 15 seconds, Press the “Return” button on the Receiver, then press Play on the CD Player. Now the display showing the DSP 1 st firmware version, Within 3 seconds, press the Tone “ +“ button. This case wait for another 10 minutes before switching OFF manually. It is possible, that the unit will not switch OFF automatically, in When the writing process has finished the display will say “Complete!”, then “Clear”, then the The Receiver’sĭisplay will now say “S/PDIF Update…” for about 15 seconds then “Writing…” for about 30 seconds. Version, press the “CD” button on the Receiver, then press Play on the CD Player. Within 3 seconds, press the Tone “ +“ button twice. This will show in the display the main firmware versions Please put the CD into the CD player and connect the player to Optical Input 1 of the receiver.Ģ. Unzip the file, burn it as Audio-CD and finalize it.įile CD_SR6050_08214A.wav is used for TX SR 605 only!įile CD_SR805 123_08214A_07518A_07820B.wav is used for all other models of x05 series. ONKYO advise that if the writing process does not work, please try a different player.ġ. Some CD/DVD players are not suitable for this update. If the writing process is only partially completed, the Receiver’sįlash IC may need to be replaced. Note: Warning! During the writing process, DO NOT turn off the power or disconnect To carry out the update you will need the software supplied by ONKYO, a PC with the possibility to burnĪ an Audio-CD, a CD player with optical output, an optical cable and your Receiver! DSP Firmware Update of TX SR 605, 705, 805, 875 and TX NR 905īugfix: Pop-noise with some HD-DTS material
0 kommentar(er)
